Premium

Premium Roof and Paving

PrintEmail
 

Prominent Premium Roof & Paving is a superior high quality, UV resistant, acrylic sheen coating with excellent adhesion qualities to handle expansion, contraction and flexibility. Combining performance and long lasting colour durability.

Products Applications:
Roof & Paving, Paving (Roof & Floor), Exterior and Roof & Floor

Purchase:
Prominent Premium Roof and Paving is available in the following sizes: 1lt , 5lt and 20lt 


Description

Prominent colourants are Lead Free specifically formulated for use with Prominent Pro-Matic tinting system.

Please note: Every care has been taken to ensure that the colours displayed on this website reflect the actual paint colour as accurately as possible. Colours may vary due to your screen settings and resolution. Always consult a Prominent Paints colour card or stripe card before making your final colour choice.

 
BLACK
 
BLUE GREY
7104-R89B
 
CHARCOAL
8003-R79B
 
PLUM
8743-Y91R
 
LIGHT BROWN 610
6915-Y59R
 
GREEN
6026-G04Y
 
COSMOS
4941-R93B
 
DEEP GREEN
7013-G
 
TERRACOTTA
5430-Y75R
 
RED
4352-Y77R
 
DARK CHOCOLATE BROWN 660
7909-Y78R
 
NUGGET
4011-Y27R
 
WHITE

Appearance: Low sheen
Spreading Rate: 3 - 8 m²/l per coat depending on the type of surface to be painted and the surface texture and porosity. E.g. Cement tile roofs 3-4m²/l per coat & Galvanised Roofs 5-6m²/l per coat
Solids: ± 50% by mass and ± 33% by volume
Density: ± 1,25 kg/litre
Recommended Dry Film Thickness: 2 coats x 40μm per coat = 60μm
Viscosity: ± 90 Kµ
Flash Point: Non-flammable

Storage:

  • Keep containers properly sealed
  • Store away from direct heat, sun and severe cold in a place with adequate ventilation

Available Sizes: 1Lt, 5Lt, 20Lt
Colours: Standard colours as per colour card. Tint bases to tint most of the colours on the tint system
Life Expectancy: 12 Years, Roofs only

Respecting The Environment:

  • Lead free
  • Dispose of excess product and containers in a responsible manner without harming the environment

Features

  • Good UV resistance hence does not chalk. Normal fading of colours will take place over time.
  • Water based for easy cleaning and short recoating periods.
  • Hardwearing.
  • Durable against normal weather conditions.
  • Easy to apply.
  • Lead free and can be tinted to specific colour requirements
     

Intended Usages

  • Direct application to new or previously painted, correctly prepared cement tiles, galvanised iron roofs and paving surfaces.
  • Can also be used on galvanised garage doors, galvanised gutters, cement and sheet metal, cladding, garden pots, window sills and fascia boards.
  • As a waterproofing topcoat over saturated membranes.

Application Details

  • Mixing: Stir well before use with a flat paddle to a homogenous consistency. Stir occasionally during use.
  • Method: Block brush, roller or airless spray gun.
  • Thinning: Not recommended.
  • Cleaning: Remove as much of the product as possible from the application equipment before cleaning with water.

Conditions: 
Temperature between 5°C and 40°C. Relative humidity of less than 85%, preferably between 10:00 and 16:00. Ideally apply when the temperature of the substrate is at least 2°C above dew point.

Drying time:
 Touch dry - 30 minutes - 1 hour at 23°C. 
Note: Higher temperatures will accelerate the drying times (approximately halved for every 10°C increase), whilst lower temperatures will retard the drying time (approximately doubled for every 10°C decrease).

Recoating time: 4 hours at 23°C.

Requirements: Two coats.

Surface Preparations
New Galvanised Sheeting:

  • Remove fabricators pre-treated oil, oxidation or any other contamination with Prominent Multi Surface Etch Cleaner and abrasive pads.
  • Ensure that a water break-free surface is obtained. Rinse well and allow drying before applying 1 coat Prominent Galvanised Iron Primer

New Chromadek Sheeting:

  • Wash down with Prominent Multi Surface Etch Cleaner and abrasive pads.
  • Ensure that a water break-free surface is obtained. Rinse well and allow drying.
  • Apply 2 coats Prominent Ultra Prime.

Weathered Galvanised Sheeting:

  • Loose rust and oxidation must be mechanically removed.
  • Clean with Prominent Multi Surface Etch Cleaner and abrasive pads to a water break-free surface.
  • Rinse well and allow drying before coating with 2 coats Prominent Rust Primer. 

Cement Roof Tiles:

  • Must be cleared of any algae and fungus before painting.
  • High-pressure water wash the surface or alternatively scrub down with wire brush and running water to remove powdery or chalky surfaces. Allow to dry.
  • Apply 1 coat Prominent Surface Restorer. 

Fibre Cement:

  • Prepare and prime with Prominent Dampcure as per technical data sheet.

Cement Floors (wood floated):

  • Chemically etch with Spirits of Salt diluted 1:10 with water until well etched and free of efflorescence.
  • Rinse thoroughly with water under pressure.
  • Allow drying. 

Cement Imprint Paving:

  • High pressure water jet cleaning. Allow to dry. Apply 1 coat Prominent Surface Restorer.

Cement Pavers:

  • High pressure water jet cleaning. Allow to dry. Apply 1 coat Prominent Surface Restorer.

Redecorating

Galvanised - Acrylic based, Sound:

  • Clean with high-pressure water jet at 180 bar and rotating nozzle to remove chalkiness and loose flaking paint and/or clean with wire brush, scraping and sanding.
  • Areas showing red rust should be abraded back to bare metal.
  • Wash down with Prominent Multi Surface Etch Cleaner and an abrasive pad and rinse thoroughly with high pressure water. Allow to dry.
  • Prime exposed sheeting with 2 coats Prominent Rust Primer. 

Galvanised - Poor Condition:

  • Remove all paint and treat as Weathered galvanised sheeting under New Work.

Cement Tile - Acrylic based, Sound:

  • Clean with high pressure water jet at 180 bar and rotating nozzle to remove chalkiness and loose flaking paint and/or clean with wire brush, scraping and sanding.
  • Allow drying.
  • Prime exposed unpainted cement tiles with Prominent Surface Restorer, allow drying.

Cement Tile - Poor Condition:

  • Remove all paint and treat as cement roof tiles under New Work.

Bitumen Aluminium/Aluminium:

  • Not recommended.

Micaceous Iron Oxide:

  • Remove all loose material and do a masking tape test before proceeding.

N.B Friable and powdery surfaces require special attention before painting. If in doubt to the correct preparation contact Prominent Technical Department. In all cases first perform a masking tape test before painting to ensure a sound surface is achieved before painting.

Limitations

  • Prominent Premium Roof and Paving only carries a 12 years life expectancy when used on roofs.
  • Prominent Premium Roof and Paving can only be applied to specified substrates and under the recommended conditions.
  • Adhesion to highly polished cement and gloss enamel floor paints is not good enough to ensure durability.
  • Cannot be applied to wet or damp surfaces or in conditions other than specified, or if rainfall or dew is imminent.
  • Weathering takes place over time. Brighter colours tend to weather more.
  • Metal roofs must not be exposed to rain within 24 hours after application.
  • To ensure colour consistency of the applied roof coating, check that the batch numbers are the same on all containers. Where batch numbers differ, intermix before use.
  • Not recommended for application to surfaces coated with Bituminous Aluminium or Aluminium paint.
  • Do not apply to surfaces where the temperature is less than 10°C.
  • Could be slippery on steep inclines and when wet and prone to marking with tyres.
  • Prominent Premium Roof and Paving is not designed for the purpose of collecting rain water off painted roofs for drinking purposes. It is therefore essential for customers who collect rain water from painted roofs for drinking purposes to follow stringent guidelines. For more information on these guidelines contact Prominent Paints Technical Department on 0861 776 646 or 011 389 4746.

Safety

  • Keep out of reach of children.
  • Ensure to maintain good ventilation during application and drying process.
  • Wear a suitable dust mask if sanding.
  • In case of skin contact, wash with soap and water or a recognised skin cleaner. Avoid contact with eyes. In case of contact with eyes rinse immediately with running water and seek medical advice.
  • If product is ingested drink plenty of water. Do not induce vomiting at any time. Seek medical advice.
  • Do not smoke while painting.
  • Refer to the Material Safety Data Sheet (MSDS) for detailed information about the product and transportation and classification criteria. MSDS is available on www.prominentpaints.co.za or from Prominent Customer Service Department.
  • To avoid any risk of spillage, always transport in a secure upright position.
  • If the surface to be painted is asbestos then the preparation, cleaning and/or removal of broken asbestos sheeting needs to be done in compliance to the Asbestos Regulations, 2001 of the Occupational Health and Safety Act 1993. (ACT NO 85 of 1993). Contact Prominent Paint Technical Department on 0861 776 646 or 011 389 4746 if a copy of the Asbestos Regulations is required.
  • Keep out of reach of children.
  • Ensure to maintain good ventilation during application and drying process.
  • Wear a suitable dust mask if sanding.
  • In case of skin contact, wash with soap and water or a recognised skin cleaner. Avoid contact with eyes. In case of contact with eyes rinse immediately with running water and seek medical advice.
  • If product is ingested drink plenty of water. Do not induce vomiting at any time. Seek medical advice.
  • Do not smoke while painting.
  • Refer to the Material Safety Data Sheet (MSDS) for detailed information about the product and transportation and classification criteria. MSDS is available on www.prominentpaints.co.za or from Prominent Customer Service Department.
  • To avoid any risk of spillage, always transport in a secure upright position.
  • If the surface to be painted is asbestos then the preparation, cleaning and/or removal of broken asbestos sheeting needs to be done in compliance to the Asbestos Regulations, 2001 of the Occupational Health and Safety Act 1993. (ACT NO 85 of 1993). Contact Prominent Paint Technical Department on 0861 776 646 or 011 389 4746 if a copy of the Asbestos Regulations is required.

Copyright © 2017 Prominent Paints