A high quality, alkali resistant white primer with high obliteration. Formulated with excellent penetration and adhesion for subsequent top coats.
Prominent Select Water-Based Plaster Primer is available in the following sizes: 1lt , 5lt and 20lt
Appearance: Matt finish
Spreading Rate: 4 - 8 m²/litre depending on surface texture and porosity.
Solids: 50% by mass and 35% by volume.
Density: 1,55 kg/litre.
Recommended Dry Film Thickness: 1 coat at 40µm.
Viscosity: ± 120 Kµ.
Flash Point: Non Flammable
Life expectancy: 7 Years, interior and exterior (as part of a system using 7-year topcoats)
Available Sizes: 1Lt, 5Lt & 20Lt
Respecting The Environment:
Surface dry: 30min to 1 hour
Note: Higher temperatures will accelerate the drying times (approximately halved for every 10°C increase), whilst lower temperatures will retard the drying time (approximately doubled for every 10°C decrease).
Recoating time: 4 hours.
Requirements: One coat.
Surfaces must be sound, clean and dry (moisture content below 15%) before painting. Plaster sand to comply with SABS 1090 requirements. Plaster mix must have a minimum thickness of 10mm, free from soft and friable material and comply with SABS 0164-1 for strength (MPA).
1. New work:
1. 1 Exterior cement plaster Apply directly
1. 2 Interior cement plaster Apply directly
1. 3 Gypsum boards Apply directly
1. 4 Concrete Clean with ProGold GP Cleaner diluted 1:10 with water and an abrasive pad, rinse with water and allow to dry.
1. 5 Cement Bricks Apply directly
2.1 Not recommended as a primer over previously painted surfaces.